Spectra Logic 10000 - Manual (Page 59)

Chapter 5. Operating the Library
59
Moving Tapes
To move a single tape, use the Move Tapes screen. To access this screen, from the main
screen, touch Main > Move Tapes.
To move a tape:
1. Place a tape into the door slot. The door indicator on the Move Tapes screen
darkens, indicating the tape is loaded into the door.
2. Touch the slot or drive to which you want to move the tape. A message appears
in the upper left corner of the screen indicating which source location is
selected.
Note: If a bar code scanner is installed, and the tape has been read by
the bar code scanner, the bar code label will also appear in the
upper left corner of the screen.
3. Touch the screen button corresponding to the destination of the tape. The
library moves the tape.
• If you select an occupied destination, the library displays the message Move
Destination is Full. Touch OK to clear the message. Touch a valid destination
button to re-initiate the move.
• To cancel a move after a source has been selected, press the source button a
second time.