Spectra Logic 10000 - Manual (Page 89)

Chapter 6. Maintaining the Library
89
Packing the Library for Shipment
If you are shipping the library:
From One Location to Another Note the packing procedures outlined under Packaging,
below.
To Spectra Logic for Service First contact Spectra Logic Technical Support to obtain a
Return Materials Authorization (RMA) number and the correct shipping address (see
Chapter 8. Technical Support and Service). Then follow the instructions under
Packaging, below.
Caution: The library warranty is voided by shipping the library without
the proper original packaging (for full warranty details, see
Limited Warranty on page 106). The following steps describe
how to properly pack the library for shipment.
Packaging
To pack the library for shipping:
1. Unload all tapes from the library, including tapes in the tape drives as well as
any tapes in the carousel slots.
2. Power off the library.
3. Remove all attached power, SCSI, and serial connections, including SCSI
terminators or Fibre Channel connections.
4. Place the anti-static bag over the library.
5. Place the library on top of the bottom foam cushions in the box (see Figure 6-6
on page 90).