Spectra Logic 10000 - Manual (Page 28)

Chapter 3. Preparing the Library
28
Preparing to Connect the Library
Before connecting the library to the host system, you must prepare the library by
completing the following steps:
1. Select the mode of library operation. See Selecting the Mode of Library
Operation on page 29.
2. If a SCSI interface library, set the library SCSI IDs, or, if a Fibre Channel
interface library, set the library for soft or hard addressing. See Setting SCSI IDs
on page 36.
3. Set the library configuration switch. See Setting the Library Configuration
Switch on page 38.
4. Connect the appropriate cables, terminators, or GBICs. See Connecting the SCSI
Cables and Terminators on page 39, Connecting the Serial Cable on page 40,
and/or Connecting the Library to Fibre Channel on page 41.
5. Connect AC power to the library. See Connecting the AC Power on page 43.