Spectra Logic 10000 - Manual (Page 77)

Chapter 5. Operating the Library
77
Using the MCE Utility
To access the MCE screen, touch the MCE button from the main menu screen. The MCE
Select screen appears (Figure 5-8).
To copy a non-AIT tape to an AIT tape:
1. Select the location of the source tape. Touch the + or - symbols on the Source ID
box to scroll through the list of drives, and select one as the source drive.
The information box to the right of the Source ID selection box shows the
source of the data. Your source can be any of the drives in the library or any
device on either of the SCSI busses attached to the library.
2. Select the location of the destination tape. Touch the + or - symbols on the
Destination box to select the destination drive.
The information box to the right of the Destination box shows the destination
for the data. The destination drive can be any library drive.
3. Touch Copy to begin copying from the source tape to the destination tape.
Figure 5-8 The MCE Select screen.
Selection Box Information Box Meaning
– Source ID + 4 Bus 1 The source tape is in a device with SCSI ID 4 on Bus 1.
– Destination + Drive 1 The destination tape is in Drive 1 in the library.