Sony OXF-R3 - Manual (Page 155)

Chapter 5 Control Screens
5-41
Chapter 5 Control Screens
outputs have been selected. When digital outputs are set, the Word Length
is displayed here. Clicking on it cycles through 16, 20 and 24 bit settings.
NAME – MAIN OUTPUT 1 lower middle right
Click on this to display a pop-up as shown in Figure B. Either click on a
name already displayed or click on NEW ENTRY and use the QWERTY
keyboard to type in a name of up to 8 characters. Press ENTER when
finished.
SAMPLE RATE CONVERTER – MAIN OUTPUT 1 lower right
This indicator turns red and reads “SRC ON” when a digital source is
selected which has its SRC turned on. SRCs are controlled via the
PREFERENCES GUI, described earlier in this chapter.
MAIN OUTPUTS 2, 3 & 4
The assignment operations for MAIN OUTPUT 1 apply to 2, 3 and 4.
LP FILTER – Lower middle block
Low Pass Filter for the SUB output. Click on the lower left button to
switch the filter section in and out of the signal path. Set the frequency
with the button to the lower right, 70 or 100Hz. The slope is 24dB/Octave.
To assign an insert on the MAIN OUTPUT BUS
The Insert selectors are laid out in the form of a set of Surround LS in the
section headed ‘MAIN INSERT’.
Figure B
MASTER GUI - MAIN OUTPUT BUS scribble pop-up