Sony OXF-R3 - Manual (Page 47)

Chapter 3 Getting Started
3-21
Chapter 3 Getting Started
1
Press {ACCESS} for the desired Channel.
2
At the Input Channel & Inserts panel, press either
{MIC} or {LINE} as required, and set the input GAIN
knob to a suitable setting.
3
At the same panel, select ‘MULTI’ in one of the
eight windows. Do this using the { + } and { – }
buttons, and then press the large { IN } button.
4
At the Routing panel, select the tracks required in
the ROUTE TO TRACKS section. The Pan
works across odd and even numbers in Stereo.
5
On the Select To Faders panel, press {M/T SEND} .
6
To pan between tracks, press {CUT} , if it is lit
which sets the pan into operation, and adjust the
Pan Knob accordingly.
7
Adjust the level to tape using the Fader. Check the
meter level for the track to which the signal is
routed.
3-10-3 To Send Signals to Tracks on Tape
1 3 4 7 5 2 6