Sony OXF-R3 - Manual (Page 170)

6-8
Chapter 6 Technical Descriptions
Chapter 6 Technical Descriptions
6-2 Channels Section Panels
4 Upper Electronic Scribble (6 Character dot display per Fader)
Displays the audio source name. This may be selected from a table of
source names via colour LCD screens when selecting signal sources. The
name may also be typed in via the central QWERTY keyboard. It also
displays gain level in dBs if the SHOW VALUE function is selected.
5 Lower Electronic Scribble (6 Character dot display per Fader)
Displays the channel number and any grouping assignment. Displays the
channel source name if SHOW VALUE is selected.
6 ABS and TRM Push-Buttons
Described under Session Management™ (Chapter 7).
7 Touch Sensitive Fader Knob and Tactile ‘Write’ Button
Functions described under Session Management™ (Chapter 7).
There are 48 channel faders on the control surface of the OXF-R3, which
can control a much greater number of channels using Fader Paging. The
SELECT TO FADERS panels, described in the following section, allow
any bank of 24 channels to be selected on either side of the centre section
at any time.
Control Grouping
Press and hold {ACCESS} on a central Control Group Fader until it turns
amber. Latch {ACCESS} on the channel faders to be slaved. A maximum
gain of 10dB can be added to a channel using a Control Group.
Use the same procedure to release slaves except that once the Control
Group {ACCESS} has turned amber and its slave {ACCESS} buttons are lit,
un-latch the slaves as required.