Sony OXF-R3 - Manual (Page 285)

Chapter 7 Session Management
7-25
Chapter 7 Session Management
in the ‘FM’ section for a different ‘from’ point as a
Cue point or click on the timecode entry for an edit
pop-up. Clicking on the large
4 and $ buttons
nudges the timecode. The merge transition can be
selected as a butt or timed ramp according to the
icon to right of the ‘FM’ label.
5
An end time must be specified in the SOURCE
‘TO’ section using a similar method used to set the
start time, specified in step 4. In this example it is
‘CHORUS 1’, which is effectively the end of
Verse 1.
6
A destination within the Working Mix must be
specified in the NEW LAYER ‘FM’ section. The
procedure is a repeat of step 4 but without needing
to specify a butt or ramp. In the example it is
‘VERSE 2’. Once a from (‘FM’) time is specified
the ‘TO’ time is entered automatically.
The ‘TO’ entry itself can be edited if required.
MERGE/ASSEMBLE - ADD LAYER pop-up
Note:
7
Further options include selecting the components
in the merge, the default being ALL which
includes all channels (CHS) and the centre section
(CEN). The example shows that CHS has been
selected in the SOURCE block upper left.
8
The selection process can be taken further to select
specific channels by clicking on the numbered
buttons. The example shows that channels 1-12,
23, 24, 33 and 34 have been selected. The source
data will be applied to the same numbered
channels but can be specified differently by
clicking on DESTINATION.
9
A further option, the field at left lower middle,
allows individual channel and centre section
components to be specified by highlighting them.
10
{ENTER} or click on OK to complete the merge.