Sony OXF-R3 - Manual (Page 283)

Chapter 7 Session Management
7-23
Chapter 7 Session Management
1 Pan knob (Press for Switch)
2 Red Absolute LED
3 Green Trim LED
To enable a PAN to have its moves recorded, first
latch {READY ABSOLUTE} below the central LCD.
Then press the PAN knob and its red LED flashes to
show that the system is ready to record absolute
moves. De-select {READY ABSOLUTE} or roll the tape,
in which case it will be de-selected automatically.
Press the PAN knob again, either before or after the
tape is rolling, and the LED will light solidly,
indicating that moves will be recorded. Roll-back for
the knobs works in the same way that it does for
faders. The difference is that instead of the knobs
moving, the LEDs in the skirts of the knobs reflect any
automation moves.
Assignable Pan knobs
When the moves are complete, press the PAN knob
again and the red LED flashes indicating that the mode
has reverted to ready absolute. Use {READY CANCEL}
to take the PAN knob out of ‘ready absolute’ status.
To trim PAN moves, first latch {READY TRIM} below
the central LCD, then press the PAN knob so that its
green LED flashes. De-select {READY TRIM}, or allow
it to be de-selected automatically when the tape starts
rolling. Press the PAN knob either before or after
rolling the tape. The green LED will light solidly,
indicating that any trimming moves will be recorded.
Whilst the knob is in the ready state, the LEDs around
the skirt of the knob will indicate previous moves. The
position of the knob at the drop-in point i.e. when the
knob is pressed, becomes the null point for any
trimmed moves.
When the moves are complete, press the PAN knob to
drop back to ready status, then press {READY CANCEL}
to drop out completely.
7-5-11 To Automate a Pan Move (or any other Knob)
AFL CUT AFL CUT AFL CUT AFL CUT
3
2
1