Suburban Mfg REGAL INTENSIVE CARE UNIT 12019-01-NGFREP - Manual (Page 149)

Form No. 702718 Rev. A March, 2005 137
Owner’s Manual - Regal Intensive Care Unit
Chapter 6 - Troubleshooting
General
The following procedures will help you fix most of the problems
that you might encounter with your SSCI Regal Intensive Care
Unit. If necessary, please feel free to call SSCI Customer Service
at (847) 537-9320, ext. 3518 (in Illinois) or 1-800-323-7366.
Our experienced technical support personnel will be glad to help you.
For more information on contacting SSCI, refer to SSCI Contact
Information on Page 7.
Part numbers for available replacement parts are shown in Table 3
on Pages 71 and 72. To order replacement parts, refer to Parts
Ordering Procedure on Page 73.
WARNING: Oxygen is a highly combustible gas. Avoid the use of open flames,
smoking materials, or equipment capable of producing sparks in any area in
which oxygen is being used. Before servicing or performing maintenance on
this equipment, make sure the oxygen supply is turned Off at the source.
Possible problems are listed below:
„
ICU will not turn on. ........................................................................................ Page 139
„ Circuit breakers keep tripping. ...................................................................... Page 140
„ Oxygen flow is inadequate. ............................................................................ Page 141
„ Oxygen flow is excessive. .............................................................................. Page 142
„ Alarm keeps going off.................................................................................... Page 143
„ Alarm system does not work. ......................................................................... Page 144
„ Heat will not come on or will not hold constant. ............................................... Page 145
„ Cooling will not come on or will not hold constant. .......................................... Page 146
„ Floor heat doesn’t work or will not hold constant. ............................................ Page 147
„ Ventilating fan does not work. ........................................................................ Page 148
„ Circulating fan does not work. ........................................................................ Page 149
„ No readings on digital readout. ...................................................................... Page 150
„ Excessive carbon dioxide in the animal compartment. ................................... Page 151
„ No reading on oxygen concentration meter. ................................................... Page 152
„ Calibration knob will not move the calibration needle. .................................... Page 153
„ Cannot move the set-point needle in the oxygen concentration meter ............. Page 154
„ Floor temperature fuse keeps blowing. .......................................................... Page 155