Sony SRP-X700P - Manual (Page 11)

11
(1) In one room application, The voice signal from the main system is routed to the sub system.
Setup example;
- A voice signal (microphone) is routed from OUTPUT -8 of the X700P in main system, to LINE INPUT-2 of
the X700P sub system, as well as routing from OUTPU-7 of the main X700P for its ceiling speakers.
- SCENE MEMORY-2 in both X700Ps is recalled by using a button on the CONTROL BOX.
- SCENE MEMORY-2 of the main X700P makes ASSIGN of every MIC INPUT apply to OUTPUT-8, to
route the voice signals to both main and sub X700Ps which use the ceiling speakers.
- SCENE MEMORY-2 of sub X700P makes only ASSIGN of LINE-2 apply to OUTPUT-7, to receive the
voice signal. The other mic and line sources connecting to t he sub system are not assigned to speakers.
(2) Line sources such as MD, DVD/CD, PC etc are reproduced from the f ront speakers with an external
amplifier (connected to OUTPUT-1&2 of the main X700P) and satellite speakers with an another e xternal
amplifier (connected to OUTPUT-3&4 of the main X700P).
- Input channels of line sources are assigned to OUTPUT-1, 2, 3 and 4. Delay of the main X700P is set up for
OUTPUT-3&4 to remove any echo caused by distance between the front and satellite speakers, on OUTPUT
SCREEN of GUI.
NOTE: The front speakers are recommended to be high sensitivity and input power, for grater reliability and to
provide enough sound level.
2-2 (2) System configuration example: One room without a partition wall
Ceiling speaker (6-8W 70V line)
Front speaker
DVD
VHS
Cassette
Deck
PC-1
PC-2 PC-3
Connecting to AV/RGB selector Data Projector
Powered Mixer SRP-X700P
(Tuner module UWP-X)
MD
WD
Mic
WL
Mic
Power Amp
Satellite speaker
Power Amp
Ceiling speaker (6-8W 70V line)
DVD
VHS
Cassette
Deck
PC-1
PC-2 PC-3
Connecting to AV/RGB selector
Parallel
Control
Mic
source
Control
Box
MD
WD
Mic
WL
Mic
Powered Mixer SRP-X700P
Antenna
(Tuner module UWP-X)
Front speaker
Data Projector
Power Amp
(2) Sub system
Not used
Not used
Antenna
Antenna
(1) Main system