Sony SRP-X700P - Manual (Page 6)

6
The MD recorder is used for recording
presentation. This assignment is turned off
to avoid feedback. When the MD is played,
the output is from front speakers due to
assignment of the speakers above. If it’s required to set different output levels of line sources from
microphone signals for recording, it’s possible to attenuate each
input on the ROUTING SCREEN by right-clicking of PC mouse
to show MENU to select a level of 0 to –20 dB.
If attenuation is applied,The color of the button changes to ‘blue’
from ‘green’ to indicate that attenuation has been applied. Green
indicates “No attenuation”.
Indexes being written on
BLOCK SCREEN, are
shown on the ROUTING
SCREEN.
To assign line sources
to front speakers
(OUTPUT-1&2) and
microphone sources to
ceiling speakers
(OUTPUT-3)
To assign mic and line sources except for MD to a recorder (MD)
1-3 (4) Input Connection of SRP-X700P and Assignment Setup
WD & WL microphone/antenna for WL/AV devices
• With this configuration, DVD, VHS and Cassette Deck are connected to AV/RGB input of SRP-X700P.
• MD is connected to Stereo Input of the X700P. REC output of the X700P is connected to the MD.
• DVD is connected with composite video. In this situation up to 3 PCs can be used.
WL1 WL2
INPUT of
SRP-X700P
LINE4 INPUT
LINE3 IN
+48V +48V +48V +48V
1 2 3 4
L
R
FRONT
COMPONENT/RGB
B
MIC INPUT
A C D E F
VIDEO
ANT IN a ANT IN b
S VIDEO
MIC5/LINE1 IN
L
R
L L
R
REAR CENTER
WOOFER
FRONT
L
R
REAR CENTER
WOOFER
L
R
ON OFF O N OFF O N OFF ON OFF
DC
9V OUT
35mA MAX DC
9V OUT
35mA MAX
R
MIC6/LINE2 IN
(+48V) (+48V)
MIC
LINE
MIC
These channels are
used for wireless mic
+48 V switch is turned off, or MIC
position is selected
XRL female – XLR male
BNC – BNC
Phono <---? Phono
Antenna
D-sub
<?
D-sub
PC1 (DT) PC2 (LT) PC3 (LT)
Antenna
DVD
VHS
MD
Cassette Deck