Sony SRP-X700P - Manual (Page 16)

16
To open ROUTING SCREEN of the Main X700P
To assign line sources to the
Front Speakers.
No assignment of mic
signals for less feedback.
To assign to the Satellite
Speakers to rout sound of the
main system to sub system
area.
The OUTPUT-7 is assigned to
rout mic signal to internal 70V.
No assignment of line sources.
To assign mic sources to rout
to the sub system because of
the “One Room Operation”.
Assignment of mic and line sources except for MD source, to a recorder (MD). The MD source is not assigned to the MD
recorder to avoid feedback caused by loop during recording.
Instead of this assignment, mic signals are only assigned to RECOUT-1 (L channel of MD), line sources are only sent to
RECOUT-2 (R of MD), for clearer sound in reproduction.
To open OUTPUT SCREEN of the Main X700P GUI, to set amp and delay for output -3&4
To select 70V LINE on the MODE box.
Due to selection of the 70V LINE, CH 2
box is closed as amplifier is set to mono
operation.
To open OUTPUT SCREEN of the Main X700P
(b) To select 2 for SCENE No.
And memo about operation, etc.
(c) Check buttons including
ROUTING at least.
(d) Press button to STORE.
The INFORMATION box may be used to provide more detailed information.
(There is not a separate INFORMATION box for each SCENE MEMORY.)
If the “2-Room Operation” is
mainly used, the SCENE No.1
is selected on Power On
Setting box.
Select delay unit in either ‘m sec’,
‘feet’ or ‘meter’.
To set each delay parameter of OURPUT-3&4, depending
on distance between front and satellite speakers.
2-3 (4) Setup for “One Room Operation” of X700P Manager GUI
(C) SETUP of Main X700P for “SCENE MEMORY-2”
(a) To avoid inadvertent operation, scene recall buttons of front
panel are not recommended to use. The Control Box is
recommended to recall.