Sony SRP-X700P User Manual
Page 17
17
To open ROUTING SCREEN of the Sub X700P
No assignment to the Front
Speakers. Because of “One
Room Operation”, any local
input sources of sub system are
not reproduced.
The Sub-system has no
satellite speakers
To assign LINE2 (a signal from
main system) to rout from the
internal 70V amp and ceiling
speakers because of the ‘One
Room’ Operation.
No assignment to a recorder
because the the recorder of sub
system is not required.
To open OUTPUT SCREEN of the Sub X700P GUI to set amplifier up
To select 70V LINE on the MODE box. Selection of the 70V,
LINE, CH 2 box is closed as amplifier is set to mono
operation.
To open OUTPUT SCREEN of the Sub X700P
(b) To select 2 for SCENE No.
And memo about operation, etc.
(c) Check buttons including
ROUTING at least.
(d) Press button to STORE.
The INFORMATION box may be used to provide more detailed information.
(There is not a separate INFORMATION box for each SCENE MEMORY.)
As setup of the Main System,
the SCENE No.1 is selected.
2-3 (4) Setup for
“One Room Operation”
of X700P Manager GUI
(D) SETUP of Sub X700P for “SCENE MEMORY-2”
(a) To avoid inadvertent operation, scene recall buttons of front
panel are not recommended to use. The Control Box is
recommended to recall.