SBE HighWire HW400c/2 - Manual (Page 15)

HighWire HW400c/2 User Reference Guide Rev 1.0
I2C
Config.
ROM
Microwire
Serial
EEPROM
SRAM
Boot
ROM
Disk on
Chip
Temp
Sensors
Flash
Memor
System Controller
Discovery III
J1
PCI
J2
PCI-64
IPMI
Controller
Temp
Sensors
Flash
Memory
J3
PSB
J4
H.110
J5
Rear I/O
Layer 2
Ethernet
Switch
H.110L
Controller
Console
RJ45
Enet
RJ45
SDRAM
CPLD
Hot Swap
Controller
PTMC Site B
Config #2 or #5
GigE or
Rear I/O
TDM PCI-X
PTMC Site A
Config #2 or #5
GigE or
Rear I/O
TDM PCI-X
SDRAM
10/100/
1000
Phy
Enet
MAC
Processor
Motorola
MPC7447A
Phy Phy
Figure 1. HW400c/2 Block Diagram
2.2 Unpacking Instructions
• If the carton is damaged when you receive it, request that the carrier's agent be
present when you unpack and inspect the equipment.
• After unpacking, verify that all items listed in the packing list are present.
• Inspect the equipment for shipping damage.
• Save all packing material for storage or return shipment of the equipment.
• For repairs or replacement of equipment damaged during shipment, contact SBE,
Inc. to obtain a Return Materials Authorization (RMA) number and further
shipping instructions.
October 10, 2006 Copyright 2006, SBE, Inc. Page 3