SBE HighWire HW400c/2 - Manual (Page 25)

HighWire HW400c/2 User Reference Guide Rev 1.0
3
FUNCTIONAL BLOCKS
The HW400c/2 has six major functional blocks – the PowerPC processor, system
controller, CT Bus interface, Ethernet switch, PTMC expansion sites, and the IPMI
controller. The following sections describe these functional blocks in greater detail.
Additional features such as the connector pin outs and JTAG development support
are also described.
3.1 PowerPC Processor
The standard configuration for the HW400c/2 includes the Freescale MPC7447A
PowerPC Processor running at 1000 MHz (1 GHz) with a corresponding system bus
speed of 166 MHz. There are two additional processor variants available for the
board, which utilize the Freescale MPC7448 PowerPC Processor with a 200 MHz
system bus speed.
The operating frequency and power consumption for each processor variant is shown
in Table 6.
Table 6. HW400c/2 Processor Options
Processor Type
Operating
Frequency
(Maximum)
System Bus
Frequency
(Maximum)
Core Power
Consumption
(Typical/Maximum)
MPC7447A 1.0 GHz 166 MHz 8.0 / 11.5 W
MPC7448 1.4 GHz 200 MHz 8.0 / 15.9 W
MPC7448 1.7 GHz 200 MHz 21 / 29.8 W
3.1.1 MPC744X Development/Debug Support
The HW400c/2 provides external access to the MPC744X processor COP port, reset
and interrupt signals at headers J6, Jx6, J7, J8, and J9 (See Figure 2). A console port
is also provided on the front panel of the board though an RJ45 modular connector
(see Figure 4, and Section 3.1.2).
October 10, 2006 Copyright 2006, SBE, Inc. Page 13