SBE HighWire HW400c/2 - Manual (Page 53)

HighWire HW400c/2 User Reference Guide Rev 1.0
Table 23. Voltage Monitor A/D Port Assignments for IPMI
Supply Voltage Monitor A/D Port
5-Volt A2D1
3.3-Volt A2D2
1.1-Volt (CPU core) A2D3
1.5-Volt (System controller core) A2D4
2.5-Volt (SDRAM) A2D5
Table 24. HW400c/2 Temperature Sensor Locations
Location I 2 C Port 1 Address Device
TS0 (U84)
Controller
0
MV64462 System
TS1 (U83) CPU Internal Temperature 1
3.6.3 Hot Swap
he IPMI controller has the capability to read the state of the hot swap ejector switch,
3.6.4 Blue (Hot Swap) LED Control
3.6.5 Boot Status Monitor
There are four (4) register bits in the CPLD reserved for indicating the boot status
le
T ted IO port as
shown in Tab power-up default va r
valu r SBE us
Ejector Latch Detection
T
otherwise known as the L_STAT signal. This signal is connected to a GPIO pin on
the Zircon PM (see Table 22). L_STAT = 0 indicates the ejector latch is closed,
L_STAT = 1 indicates it is open, and that the board is about to be removed
The IPMI controller has the capability to turn on the Blue Front Panel LED. A GPIO
pin on the Zircon PM is connected through the CPLD to the LED (see Table 22).
vel from the processor. hese bits are connec
lue of the
to the Zircon PM GP
se bits is “0000.” All othe le 22. The
es are reserved fo e.
October 10, 2006 Copyright 2006, SBE, Inc. Page 41