SBE HighWire HW400c/2 - Manual (Page 55)

HighWire HW400c/2 User Reference Guide Rev 1.0
3.6.9 Zircon PM
-up, the Zircon PM is held in reset state until the 3.3V supply voltage is
within tolerance.
3.6.10 IMPI Get
The response to the IPMI command “GetDeviceID” from the Shelf Manager is of the
See Appendix A for the complete response format to
GetDeviceID.” Unique Product ID numbers (byte offsets 11 and 12) are assigned as
he three least significant bits of the Product ID numbers for the HW400c/2 board
are always “111” to maintain continuity with the earlier HW400 Product ID
ent scheme. The LSB value is also reflected in the Extended Type Register
(ETR) in the CPLD register bank. See Section 4.2.11 for details.
duct Features
(see Table 5)
Product ID number
(MSB, LSB)
Reset
At power
Device ID
standard format.
shown in Table 26
T
assignm
Table 26. Product ID number
HW400c/2 Pro
Standard Version 0x00, 0x07
October 10, 2006 Copyright 2006, SBE, Inc. Page 43