Smart Technologies Smart Board 560 and 580 Interactive Whiteboards And UF55 Projectors 99-00964-20 - Manual (Page 26)

16 Connecting Your Interactive Whiteboard System 99-00964-20 A0
Connecting the Cables to the UF55 Projector
Refer to the following diagrams as you connect the cables to the projector.
Routing the Cables
When connecting cables from the UF55 projector to the 560 or 580 interactive whiteboard, make sure all cables
pass along the top of the mounting bracket and down the left or right side of the interactive whiteboard.
Cabling for the UF55 and the ECP
To connect the power, ECP and network cables to the projector
1. Remove the projector’s cable cover.
2. Pass the cable through the boom, and then connect it to the power supply receptacle. Make sure that the
power cable is in the farthest position to the right in the cable slot.
NOTE: Don’t connect the power cable to a power outlet until all cables are connected to the projector.
Power
Supply
Cable Slot