Safety warnings – Smart Technologies Smart Board 560 and 580 Interactive Whiteboards And UF55 Projectors 99-00964-20 User Manual
Page 4
ii
Important Information
99-00964-20 A0
Safety Warnings
WARNING
• If the lamp has shattered or burst, call an
for instructions.
Do not attempt to replace the lamp. Do not touch the glass fragments because they might
cause injury. Leave and then ventilate the area where the lamp shattered or burst. Wash
your hands thoroughly if you have come into contact with lamp debris. Thoroughly clean the
area around the projector, and discard any edible items placed in that area because they
might be contaminated.
• The lamp used in the UF55 projector contains mercury. Recycle or dispose of it as
hazardous waste, in accordance with local regulations.
• Use only replacement lamps approved by SMART Technologies. Contact your
for replacement parts.
• Turn the projector off and wait 30 minutes for the lamp to cool completely before removing
the old lamp assembly.
• Never replace the lamp assembly with a previously used lamp assembly.
• Do not open or disassemble the projector as this may cause electric shock.
• Ensure that any cables extending across the floor to your SMART product are properly
bundled and marked to prevent a trip hazard.
• Make sure that an electrical socket is near to your SMART product and remains easily
accessible during use.
• Avoid turning off the projector during the lamp ignition phase as this may lead to premature
lamp failure. Before turning the projector off, keep the lamp on for a minimum of 15 minutes
after turning it on to preserve the lamp life.
• This projector detects its own remaining lamp life. Replace the lamp when lamp life warning
messages appears.
• If you continue to use the projector after the replacement message appears, the lamp might
shatter or burst, scattering glass throughout the projector head.
• When the lamp is approaching the end of its life, the message “Lamp is approaching the end
of its useful life in full power operation” appears on the screen. Contact your
service center to change the lamp as soon as possible.
• Remove the projector from the projector’s arm before servicing the lamp. Complete the
procedure described in this document before following the instructions included in your
replacement lamp box.
• Do not attempt to service the projector other than performing routine lamp replacement.
Service should be performed only by an authorized service provider. Other than the lamp
module, there are no user-serviceable parts inside the unit.
• Replacing the lamp in a boom-mounted projector might result in fall or injury.
• Uncovering the lamp while the projector is mounted on a projector’s arm might lead to
product damage or personal injury from falling pieces of glass if the lamp is broken.
• Wear protective eyewear while changing the lamp. Failure to do so can cause injury or loss
of eyesight if the lamp shatters or bursts.