Ready light isn’t lit, To resolve your unlit ready light issue – Smart Technologies Smart Board 560 and 580 Interactive Whiteboards And UF55 Projectors 99-00964-20 User Manual
Page 44
34
Troubleshooting Your Interactive Whiteboard System
99-00964-20 A0
Ready Light Isn’t Lit
If your Ready light isn’t lit, one of the following issues is occurring:
•
There is a power outage or a power surge.
•
A circuit breaker or a safety switch was tripped.
•
Your projector isn’t connected to a power source.
•
Your projector has an internal problem.
1.
Check the power source, and then make sure that all cables are connected.
2.
Confirm that your projector is connected to an active power outlet.
3.
Check that the pins on the connectors aren’t broken or bent.
4.
Make sure the Hide Display feature on the remote control is disabled.
5.
If the previous steps don’t resolve the issue, disconnect the power cable and then contact your
To resolve your unlit Ready light issue