Smart Technologies Smart Board 560 and 580 Interactive Whiteboards And UF55 Projectors 99-00964-20 - Manual (Page 48)

38 Appendix A: Remotely Managing Your Interactive Whiteboard System 99-00964-20 A0
Command Inventory
The UF55 projector responds to the commands in the tables on the following pages.
NOTES
• Commands aren’t case sensitive.
• Type commands exactly as they appear in the left column of the tables.
• Press ENTER after typing each command.
• After the projector executes a command, it generates a response. There are two ways to program the
command sequence to turn on the system, wait for the powering cycle to finish and select an input source:
– Allow the ECP to sequence the commands
– Control the sequence programmatically
1. Type on, and then press ENTER.
2. Type set input=vga1, and then press ENTER.
CAUTION • Cycling power to the projector repeatedly can lock or damage the interactive whiteboard
system. Allow at least 15 minutes for cooling before sending the on command after turning
off the system.
• Check your entries carefully before entering your commands.
To allow the ECP to sequence commands