Smart Technologies Smart Board 560 and 580 Interactive Whiteboards And UF55 Projectors 99-00964-20 - Manual (Page 45)

99-00964-20 A0 Appendix A: Remotely Managing Your Interactive Whiteboard System 35
Appendix A: Remotely Managing Your Interactive
Whiteboard System
This appendix provides detailed instructions on how to set up your computer or your room control system
to manage your SMART Board interactive whiteboard system settings.
• Programming Commands for Your SMART Board Interactive Whiteboard System Settings (this page)
– Pin Configuration on the ECP RS-232 Connector (page 36)
– Serial Interface Settings (page 36)
– UF55 Projector Powerstates (page 37)
• Command Inventory (page 38)
– Powerstate Control (page 40)
– Source Selection (page 41)
– Video Control (page 42)
– Audio Control (page 43)
– Network Information (page 43)
– System Information (page 45)
Programming Commands for Your SMART Board Interactive Whiteboard
System Settings
You can externally manage projector settings by connecting a computer or room control system to the serial
interface (RS-232) on the ECP for the UF55 projector. Using a computer connection or room control system, you
can select video inputs, start up or shut down the interactive whiteboard and request information such as
projector lamp usage, current settings and network addresses.