Smart Technologies Smart Board 560 and 580 Interactive Whiteboards And UF55 Projectors 99-00964-20 - Manual (Page 33)

99-00964-20 A0 Using Your Interactive Whiteboard System 23
Using Your Interactive Whiteboard System
This chapter describes the basic operation of your interactive whiteboard system, how to retrieve system
information and how to access the projector’s image adjustment options.
• Turning the System On and Off and Selecting an Input (this page)
• After Completing the Installation (page 24)
• Using Your UF55 Projector (page 24)
– Using Your Remote Control (page 24)
– Menu Options (page 25)
Turning the System On and Off and Selecting an Input
Your ECP has a Power button and four Input Selection buttons. You can connect up to three peripheral devices
and one host computer at the same time. You can add your own labels to the ECP buttons.
To turn on the interactive whiteboard system and select an input
1. Press the ECP’s Power button to turn on the system.
2. Press an Input Selection button to select a video source.
3. When you want to turn off the system, press the ECP’s Power button twice.
NOTE: Depending on the video source, it may take several seconds for the video signal to display.
TIP
Consider leaving the system on between uses. Repeatedly turning the system on and off can
reduce the lamp’s life span.