Siemens 2060isdn - Manual (Page 23)

Basic settings
23
I_KAP03.FM5
Gigaset 2060isdn, Inland:
8.12.98 A30853-X210-B101-1-19
Setting point-to-multipoint
Point to multipoint is the default access mode of your Gi-
gaset 2060isdn. Use the procedure described here to
configure the point-to-multipoint mode and define opera-
tion as local or multicell (in other words mobile units con-
figured for use with one or more base stations).
When configured in this way your Gigaset 2060isdn is
compatible only with a point-to-multipoint access in-
stalled by your network provider. For more information on
multicell operation, ➔ page 81.
t Meaning: see footnote
After confirming - and thus activating - “Point to MP.”, se-
lect:
or
If you select multicell operation:
Enable or disable calls from and to multiple base stations.
Ž The comfort mobile unit is idle. You will be prompted to
enter the system code in the course of this procedure
(default code: “0000”).
.t Service t System settings t Configuration t Point to MP.
t Local op. For operation with one base station (single-cell mode, de-
fault)
t Multicell op. For operation with more than one base station.
It is not advisable to enable calls between inter-
nal users across multiple base stations unless
your Gigaset 2060isdn is connected to a private
branch exchange.
The PBX must support this internal traffic. For
more information on point-to-multipoint opera-
tion ➔ page 17 and ➔ page 84
t means: browse withu or u and press x to confirm Z NEXT OK