Konica Minolta NON-CONTACT 3D DIGITIZER VIVID 9i - Manual (Page 20)

18
Connecting the VIVID 9i to a Computer
Setting the SCSI ID No.
In order for the computer to recognize that the VIVID 9i is connected to the computer via the SCSI interface,
a SCSI ID No. (0 to 6) must be set for the VIVID 9i.
M
emo
SCSI ID No. 5 has been set as the default setting before shipment.
N
ote
If other devices are connected to the computer via the SCSI interface, make sure that the SCSI ID No. of the VIVID 9i
differs from those set for the devices.
[Setting Procedure]
1 Press .
The MENU view will appear.
2 Press to locate the arrow cursor to “SC-
SI SETTINGS”.
3 Press (or ).
The SCSI SETTINGS view will appear.
4 Press to locate the arrow cursor to “SC-
SI ID”.
5 Press (or ).
The currently selected SCSI ID No. will turn to pink.
6 Press to select the desired SCSI ID No.
<Settings>
• 0 to 6: SCSI ID No.
7 Press .
Setting is now complete.
N
ote
To cancel the setting and return the SCSI SETTINGS
screen to its original state, press
.
STANDARD 3 HQ ON NF ON
COLOR OFF
W.B. DEFAULT
SCSI 5 ENABLED
WHITE BALANCE
INITIAL MODE
INITIAL CONDITION
SCSI SETTINGS
INFO
→
SCSI SETTINGS
SCSI ID 5
TERMINATE ENABLED
→
SELECT
ENTER
SCSI SETTINGS
SCSI ID 6
TERMINATE ENABLED
SELECT
ENTER
ENTER
CANCEL
Vivid910-hard-E.book Page 18 Monday, October 18, 2004 3:11 PM