Konica Minolta NON-CONTACT 3D DIGITIZER VIVID 9i - Manual (Page 21)

19
Connecting the VIVID 9i to a Computer
Setting the Terminator
The VIVID 9i has a built-in SCSI terminator. The terminator is required if the VIVID 9i is the last device of
those connected in series to the SCSI interface (i.e., if only one of the SCSI ports on the VIVID 9i is used).
If the terminator is not set correctly, the VIVID 9i or devices connected to the SCSI interface may mal-
function.
M
emo
“ENABLED” has been selected as the default setting before shipment.
N
ote
“DISABLE” must be selected if the VIVID 9i is connected via the SCSI interface but is not the last device of those
connected in series, and “ENABLE” must be selected if it is not connected via the SCSI interface.
[Setting Procedure]
1 Press .
The MENU view will appear.
2 Press to locate the arrow cursor to “SC-
SI SETTINGS”.
3 Press (or ).
The SCSI SETTINGS view will appear.
4 Press to locate the arrow cursor to
“TERMINATE”.
5 Press (or ).
The currently selected option (ENABLED or DISA-
BLED) will turn to pink.
6 Press to select “ENABLED” or “DISA-
BLED”.
<Settings>
• ENABLED: Select this option if the terminator is to be
used.
• DISABLED: Select this option if the terminator is not to
be used.
STANDARD 3 HQ ON NF ON
COLOR OFF
W.B. DEFAULT
SCSI 5 ENABLED
WHITE BALANCE
INITIAL MODE
INITIAL CONDITION
SCSI SETTINGS
INFO
→
SCSI SETTINGS
SCSI ID 5
TERMINATE ENABLED →
SELECT
ENTER
SCSI SETTINGS
SCSI ID 5
TERMINATE ENABLED
SELECT
ENTER
Vivid910-hard-E.book Page 19 Monday, October 18, 2004 3:11 PM