Konica Minolta NON-CONTACT 3D DIGITIZER VIVID 9i - Manual (Page 33)

31
Replacing the Lens and Field Calibration
6 Attach the lens hood.
Align the cutouts, and then turn clockwise.
M
emo
The hood must be turned until it contacts the bayonet mount
socket.
7 Press any key.
After several dozen seconds, “PLEASE OPEN LASER BARRIER AND PRESS ANY KEY” will be
displayed on the viewfinder.
8 Press any key.
The viewfinder displays the monitor screen, and the digitizer is ready for use.
N
ote
Place a lens cap on the lens you removed, put it in its case, and store in a safe place.
9 Use the field calibration system and the Polygon Editing Tool software to calibrate the
system.
For the field calibration procedure, refer to “Field Calibration” on the next page.
R
ef.
Vivid910-hard-E.book Page 31 Monday, October 18, 2004 3:11 PM