Konica Minolta NON-CONTACT 3D DIGITIZER VIVID 9i - Manual (Page 44)

42
Adjusting the White Balance
The color of an object varies slightly depending on the type of light source. To acquire accurate color image
data, adjust the white balance as described below under the light source to be used.
When scanning, we recommend that you use a stable, flicker-free light source (such as a high-frequency fluo-
rescent lamp).
M
emo
The white balance has been adjusted under fluorescent light before shipment.
[Operating Procedure]
1 Set the light source so that the lighting condition is the same as that under which scan
is to be performed.
2 Attach the white balance cap to the VIVID 9i as
illustrated.
3 Press .
The MENU view will appear.
4 Press to locate the arrow cursor to
“WHITE BALANCE”.
STANDARD 3 HQ ON NF ON
COLOR OFF
W.B. DEFAULT
SCSI 5 ENABLED
WHITE BALANCE
INITIAL MODE
INITIAL CONDITION
SCSI SETTINGS
INFO
→
Vivid910-hard-E.book Page 42 Monday, October 18, 2004 3:11 PM