Karcher WATERCLEAN 600 CD - Manual (Page 71)

71
WTC 600 LP / MP APPENDIX
Service Handbook 08.2004
1.5 Terms and Definitions
The following scripts will be used for this manual:
Item Script Examples
keys
LED's
inlets/outlets capital letters + bold
capital letters + bold
capital letters + bold LEFT, UP, DOWN
RINSE, DISPOSAL
PUMP FAILURE, INLET VALVE
operating settings
operating parameters italics
italics ps-hard water, ps-pumps
LIM, t-rinse
operating modes
operating conditions
operating failure capitals + underligned
capitals + underligned
capitals + underligned STOP, ON
PRODUCTION; DISPOSAL
MOTOR FAILURE, FORCED STOP
The following abbreviations will be used:
– Cy-perm permeate conductivity
– t-perm permeate temperature
Remark: The terms on/off as well as STOP and OPERATION could cause mix-ups; they are
therefore defined as follows:
– On/off describes the existence/non-existence of the mains supply voltage
– STOP and OPERATION describe an operating condition which obviously only can exist
when the system is switched on.
1.6 Declaration of Conformity
The Control Unit complies with the following standards and test regulations:
(to be fixed in the framework of the CE conformity standards)