Kenwood TM-V71E - Manual (Page 16)


GETTING ACQUAINTED
FroNT PANEl
q VFO
Press [VFO] to enter VFO mode {page 1}, then rotate the Tuning control to
select an operating frequency. Press [VFO] (1s) to start VFO scan
{page 43}. Press [F], [VFO] to copy the current Memory channel or Call
channel to the VFO (memory shift) {page 36}.
w MR
Press [MR] to enter Memory Channel mode {page 1}, then rotate the Tuning
control to select a Memory channel. Press [MR] (1s) to start Memory scan
{page 44}. Select a Memory channel, then press [F], [MR] to store the current
operating frequency in the Memory channel {page 33}.
e Tuning Control
Rotate to select an operating frequency or Memory channel, change the scan
direction, select a tone frequency, etc. Press the Tuning control to enter MHz
mode (while in VFO or Call mode) or to toggle the display between the channel
name and frequency (while in Memory Channel mode). Press [F], then press
the Tuning control to enter Menu mode {page 20}. Press the Tuning control
(1s) to start MHz scan {page 4} or Group scan {page 45}.
r CALL
Press [CALL] to select the Call channel. Press [CALL] (1s) to start Call scan
{page 4}. Press [F], [CALL] to store the current operating frequency to the
Call channel {page 33}.
t F
Press [F] to enter Function mode. Press [F] (1s) to turn the transceiver key
lock function ON or OFF {page 63}.
y TONE
Press [TONE] to turn the Tone function ON. Continually press [TONE] to
toggle the functions as follows: Tone ON >> CTCSS ON >> DCS ON >> OFF.
While Tone, CTCSS, or DCS is ON, press [F], [TONE] to enter CTCSS or
DCS setup mode.