Kenwood TM-V71E - Manual (Page 46)

38
PROGRAMMABLE MEMORY (PM)
Programmable Memory (PM) stores virtually all settings currently set on
the transceiver. This transceiver provides 5 PM channels to store 5 sets of
transceiver configurations. Later, you can quickly recall any one of these
channels, depending on the operations you have in mind or the operating
environment.
The following programmable settings cannot be stored:
• Memory name
• Memory channel lockout
• Channel Display mode
• Locked-band/ Cross-band Repeater ON/OFF
1
• Repeater mode 1
• Repeater hold 1
• Repeater ID transmit 1
• Registered repeater ID 1
• Wireless remote control 1
• Answer back 1
• Remote control ID 1
• Key lock
• Power on password
2
• Memory channel/ Call channel/ Program scan memory
• Weather channel
1
• DTMF memory
• EchoLink memory
• PC port speed
• 10 MHz mode
2
• Mic sensitivity 2
• SQC data output logic 2
1 K type only
2 Can be set only by using the MCP-2A software.