Kenwood TM-V71E - Manual (Page 84)

76
AUTO:
Announcements are made automatically when changing a mode/frequency/setting.
Operation Announcement
Press [VFO] “VFO”
Press [MR] “MR”
Press [CALL] “Call”
Press [F] “Function”
Press [MENU] “Menu” + menu number
Press [PM] “PM”
Press [ENT] “Enter”
Change the operating band/
turn the power ON
“A”/“B” + “Channel” (for MR only) + “Call”/channel
number + “Channel” (for CALL only) + operating
band frequency + output power level
Change the frequency band New receive frequency
Frequency direct entry Entered key number
Memory Direct Entry mode Channel number
Press [F] in VFO mode “Memory in” + channel number + frequency
Press [F], [M.IN] in VFO mode “Memory in” + channel number + “Blank”
Press [A/B] in VFO mode “A”/“B” + frequency + output power level
Press [F] and then the Tuning
control in VFO mode
“Menu” + menu number
Press the Tuning control in
Menu mode
Setting value
Perform a Full Reset “Full reset?”
Perform a Partial Reset “Partial reset?”
Perform a VFO Reset “VFO reset?”
Perform a PM Reset “PM reset?”
Press [LOCK] (to turn the Lock
function ON)
“Lock on”
Press [LOCK] (to turn the Lock
function OFF)
“Lock off”
Tone frequency setup “Tone frequency” + frequency value
CTCSS frequency setup “CTCSS frequency” + frequency value
DCS code setup “DCS” + code value
MHz step frequency setup “MHz Step” + frequency value
10 MHz setup “10” + “MHz setup” + frequency value
Output power setup “TX Power” + power level