Kenwood TM-V71E - Manual (Page 48)

40
stORinG DAtA in PM chAnnELs
1 Confirm that the following conditions have been satisfied:
• The transceiver is in receive mode.
• Scan is not being used.
• Microphone Control is OFF.
2 Configure the transceiver with your desired settings.
3 Press [F], [PM].
• PM channel numbers 1 to 5 appear and blink at the bottom of the display.
4 Enter a channel number ([1] to [5]) corresponding to your desired PM channel.
• The settings are stored in the PM channel.
REcALLinG PM chAnnELs
1 Press [PM].
• PM channel numbers 1 to 5 and OFF appear on the bottom of the display.
2 Enter a channel number ([1] to [5]) corresponding to your desired PM channel.
• The settings stored in the PM channel are recalled.
• The selected channel number appears on the display.
• When selecting [OFF], the PM channels turn off.