Kenwood TM-V71E - Manual (Page 86)

78
VOICE RECORDER
The voice recorder provides you with 3 VGS channels for recording voice memos,
along with a single VGS channel for continuous recording. You can also prepare
automated message responses to received calls.
Each recording can last for up to 30 seconds.
■
Voice memos
To record a voice memo, for later playback:
1 Press the PF key programmed as [VGS].
2 Press and hold the key for the VGS channel number you want to store the
memo in: [F] (1), [TONE] (2), or [REV] (3).
• A beep will sound and the transceiver will enter Recording mode.
3 Press and hold the VGS channel number key again (the same key you
pressed in the previous step), then speak into the microphone to record
your memo.
• Recording begins as soon as you press the VGS channel number key, and a
timer appears on the display.
• Pressing the microphone PTT switch at this time will transmit your message as
well as record it. Do not press the microphone PTT switch if you do not want to
transmit your message.
4 Release the VGS channel number key to end the recording at any time and
store it into the selected VGS channel.
• If the memory becomes full, recording will stop automatically and store the voice
memo to memory.
• “WRITING” appears on the display while the recording is being stored to
memory.
• To exit, press [VGS] again.