Kenwood TM-V71E - Manual (Page 39)

31
Press [REV] (1s) to turn the ASC ON.
• When the ASC is ON, the icon will appear on the display.
• While direct contact is possible, without the use of a repeater, the icon will begin
blinking.
• To exit ASC, press [REV].
Note:
u
Pressing [PTT] will cause the icon to stop blinking.
u ASC does not function if you are using simplex operation.
u ASC does not function while scanning.
u Activating ASC while using Reverse will switch the Reverse function OFF.
u If you recall a Memory channel or the Call channel, and those channels are set up with the
Reverse function switched ON, the ASC will switch OFF.
u ASC causes received signals to be momentarily intermitted every 3 seconds.
TONE FREqUENcy ID
This function scans through all tone frequencies to identify the incoming tone
frequency on a received signal. You can use this function to find which tone
frequency is required by your local repeater.
1 Press [TONE] to switch the Tone function ON.
• The icon appears on the display.
2 Press [F], [TONE] (1s) to run the Tone Frequency ID scan.
• The icon blinks and SCAN appears on the display.
• To reverse the scan direction, turn the Tuning control clockwise (upward scan) or
counterclockwise (downward scan).
• To quit the function, press [F] (ESC).
• When the tone frequency is identified, the identified frequency appears on the
display and blinks. Press any key other than the Tuning control while the identified
frequency is blinking, to resume scanning.
3 Press the Tuning control to program the identified frequency in place of the
currently set tone frequency.
• The Tone function will remain ON. You can press [TONE] to switch the Tone
function OFF.
• Press [F] (ESC) if you do not want to program the identified frequency.