Kenwood TM-V71E - Manual (Page 55)

47
8 Press [F].
9 Rotate the Tuning control to select a matching channel number from U0 to
U9.
• For example, if you selecte channel L3 in step 5, select channel U3 here.
10 Press [MR] to set the channel number.
• The upper limit is stored in the channel.
• To confirm the stored scan limits, press [MR], then select the L and U
channels.
Note:
u
The lower limit must be lower in frequency than the upper limit.
u The lower and upper frequency step sizes must be equal.
u The lower and upper limits must be selected on the same band.
n Using Program Scan
1 Select your desired band.
2 Press [VFO].
3 Rotate the Tuning control to select a frequency within your desired scan
range.
4 Press [VFO] (1s).
• Scan starts at the current frequency.
• The 1 MHz decimal blinks while scanning is in progress.
• To reverse the scan direction, turn the
Tuning control clockwise (upward scan)
or counterclockwise (downward scan). You can also press microphone [UP]/
[DWN].
5 To quit Program Scan, press [VFO] again.
Note:
u
If the step size differs between the lower limit and upper limit, VFO scan will begin instead
of Program Scan.
u If the current VFO frequency is within more than one Program Scan range, the range
stored in the smallest channel number is used.