Kenwood TM-V71E - Manual (Page 52)

44
MEMORY SCAN
Use Memory Scan to monitor all Memory channels programmed with frequency
data.
1 Select your desired band.
2 Press [MR] (1s).
• Scan starts at the current frequency.
• The 1 MHz decimal blinks while scanning is in progress.
• To reverse the scan direction, turn the
Tuning control clockwise (upward scan) or
counterclockwise (downward scan). You can also press microphone [UP]/ [DWN].
3 To quit Memory Scan, press [MR] again.
Note:
u
At least 2 Memory channels must contain data and must not be locked out of scan.
u The L0/U0 to L9/U9 Memory channels will not be scanned.
u You can also start Memory Scan when in Channel Display mode. While Scan is paused on a
channel, the channel number blinks.
n Locking Out a Memory Channel
You can select Memory channels that you prefer not to monitor while scanning.
1 Press [MR], then rotate the Tuning control to select your desired channel.
2 Enter Menu mode and access Menu 202 (L.OUT) {page 20}.
3 Set the lockout to ON to lock the channel out of the scanning sequence.
• To cancel lockout, set the lockout to OFF.
• The icon appears on the display for a channel that has been locked
out.
Note: The L0/U0 to L9/U9 Memory channels cannot be locked out.