KTI Networks KS-2601 - Manual (Page 19)

15
reauthtime..... Set 802.1x Re-authentication Timeout Period
reqcnt......... Set 802.1x Max Request Count
rsip........... Set Radius Server Address
shkey.......... Set 802.1x Shared Key
supptime....... Set 802.1x Supplicant Timeout Period
svrtime........ Set 802.1x Server Timeout Period
transparent.... Set 802.1x as transparent mode
txtime......... Set 802.1x Tx Timeout Period
enable sub-commands is used to enable 802.1x authentication function.
disable sub-command is used to disable 802.1x function.
authmode sub-command is used to set the authentication mode for a
physical port. Its syntax is . . .
set dot1x authmode [port#] [auto|fa|fu|no]
- auto: the authentication mode of the port depending on the authentication
result of the port
- fa (force-authenticated): will force the port always being authentication
successful in 802.1x process and the real authentication result will be
ignored.
- fu (force-unauthenticated): will force the port always being authentication
unsuccessful in 802.1x process and the real authentication result will be
ignored.
- none: 802.1x function will not be executed on the port, i.e. disabled on the
port.
authport sub-command is used to set the handshaking port number between
the switch and RADIUS server. It could be different for different RADIUS
servers.
quiettime sub-command is used to set the quiet time value between the
switch and the user before next authentication process when authentication
fail.
re_au sub-command is used to enable the re-authentication function of the
switch. When the re-authentication time is up, the switch will start the re-
authentication process.
reauthcnt sub-command is used to set max count for re-authentication
request in the re-authentication process. If the max count is met, it will
become un-authentication state. The valid value is 1~10.
reauthtime sub-command is used to set the timeout period of the re-
authentication process.
reqcnt sub-command is used to set max request timeout count between the
switch and RADIUS server before authentication fail. The valid value is 1~10.
rsip sub-command is used to set the IP address of RADIUS server.
shkey sub-command is used to set the security key between the switch and
RADIUS server.
supptime sub-command is used to set the timeout value between the switch
and users (called “supplicant” in 802.1x) after first identification. The valid
value is 0~65535.
svrtime sub-command is used to set the request timeout value between the
switch and RADIUS server. The valid value is 0~65535.