KTI Networks KS-2601 - Manual (Page 37)

33
==============================================================
The first part is the mapping of 802.1P priority values 0~7 to the four priority
queues of the switch.
The second part is the port-based priority setting.
The third part is the 802.1P priority function status for each port.
3.20 show ratecontrol command will show current rate control setting for
each port. For example,
>show ratecontrol
[Rate Control Configuration]
Packet Drop for Ingress Limit: Disable
==========================================
Port Ingress Egress
==========================================
1 No Limit No Limit
2 No Limit No Limit
3 No Limit No Limit
4 No Limit No Limit
5 20Mb No Limit
6 No Limit No Limit
7 No Limit No Limit
8 No Limit No Limit
9 No Limit No Limit
10 No Limit No Limit
11 No Limit No Limit
12 No Limit No Limit
13 No Limit No Limit
14 No Limit 70Mb
15 No Limit No Limit
Press any key to continue ...
==========================================
3.21 show rmon command will show current RMON setting (enable/disable)
of the switch.
Its syntax is …
>show rmon
RMON Funciton: Disabled
3.22 show security command will show current Mac address security mode
for port.
Its syntax is . . .
>show security
[MAC Security Configuration]
==================================================================
Port Static MAC Number Security Control
==================================================================
1 0 No Security
2 0 No Security
3 0 No Security
4 0 No Security
5 0 No Security
6 0 No Security