KTI Networks KS-2601 - Manual (Page 29)

25
2.26 set trunk command
This switch supports three trunk groups (Trunk 1~3) maximum. They are
disabled and null trunk groups default. Users can use this command to
configure trunk function of the switch.
Its syntax is . . .
>set trunk
Syntax : Set trunk [enable|disable]
Description: Enable/Disable trunk function.
Syntax : Set trunk [1|2|3] [1:enable|0:disable]
Examples : set trunk 1 1
Description: Enable trunk 1.
Syntax : Set trunk [+/-] [port#] [trunk#]
Examples : Set trunk +1+5-7 1
Description: Add port 1,5 to trunk group 1 and
remove port 7 from trunk group 1
a. enable and disable sub-commands are used to enable/disable trunk
function of the switch.
b. set trunk [1|2|3] [1|0] is sub-command to enable/disable each trunk
connection.
c. set trunk [+/-] [port#] [trunk#] is sub-command to add/remove ports to/
from trunk groups. Only Port 1~8 is available for trunk operation.
3. show command
This command is used to show configurations of the switch. Here is the sub-
command for showing different configuration.
>show
[Command List]
?.............. Help commands
help........... Help commands
1qvlan......... Show 802.1q VLAN configuration
age............ Show aging tim
arl............ Show ARL table
automode....... Show Auto mode setting
cfg............ Show system information
dot1x.......... Show 802.1x Protocol status
guest.......... Show name and password for Guest
gvrp........... Show GVRP Protocol setting
http........... Show HTTP Protocol setting
idle........... Show idle time for Console.
igmp........... Show IGMP configuration
loopback....... Show Loopback Detection setting
mirror......... Show mirror function configuration
net............ Show network IP configuration
port........... Show switch port configuration
protect........ Show protected port setting
pvlan.......... Show Port-based VLAN configuration
qos............ Show QoS configuration
ratecontrol.... Show Rate Control configuration