KTI Networks KS-2601 - Manual (Page 21)

17
2.12 set igmp command
This command is used to enable/disable IGMP snooping function for IP
multicast operation.
Its syntax is . . .
>set igmp
[Command List]
enable......... Enable igmp snooping function
disable........ Disable igmp snooping function
2.13
set loopback command
This command is used to set the loopback detection function of the switch. If
loopback condition happens at some connection port, all the transmitted
packets will come back to the switch and cause packet storm in the switch.
That may cause the switch unstable. If this function is enabled and
loopback condition is found at some port, that port will be disabled by the
switch. You can use “release” sub-command to enable the port after its
loopback condition is removed.
Its syntax is …
Syntax: set loopback [enable|disable|release].
[enable] : enable loopback detection on port
[disable]: disable loopback detection on port
[release]: release the ports that loopback are detected
2.14
set mirror command
This command is used to configure mirror function of the switch. The
following is the sub-command for it.
>set mirror
[Command List]
?.............. Help commands
help........... Help commands
enable......... Enable mirror function
disable........ Disable mirror function
ingress........ Set mirror ingress setting
egress......... Set mirror egress setting
port........... Set mirror capture port setting
2.14.1 set mirror ? and set mirror help command
This command can show the sub-command list for “set mirror” command.
2.14.2 set mirror enable command
This command is used to enable the mirror operation.
2.14.3 set mirror disable command
This command is used to disable the mirror operation.
2.14.4 set mirror ingress command