Kohler 3.5CFZ - Manual (Page 10)

TP-5695 12/93 Safety Precautions and Instructions vii
NOTES
NOTE
HARDWARE DAMAGE! Engine and generator may
make use of both American Standard and metric
hardware. Be sure to use the correct size tools to
prevent rounding of bolt heads and nuts.
NOTE
Special attention should be given when checking for
proper coolant level. After the coolant has been drained,
it normally requires some time before complete refill of
the engine water jacket takes place.
NOTE
When replacing hardware, do not substitute with
inferior grade hardware. Screws and nuts are
available in different hardness ratings. American
Standard hardware uses a series of markings and
metric hardware uses a numeric system to indicate
hardness. Check markings on bolt head and nuts for
proper identification.
NOTE
When a fuse replacement is required, be sure fuse has
the same ampere rating and is the same type (for
example: ABC or 3AB, ceramic). Do not substitute
“clear” glass-type fuses for ceramic fuses. If ampere
rating is unknown or questionable, see Wiring Diagram.
NOTE
High-mineral content sea water (salt water) can cause
rapid destruction of all metals. Wipe up all salt water
spillage on and around generator set and keep metal
surfaces free from accumulated salt deposits.
NOTICE
This generator set has been rewired from its
nameplate voltage to:
246242
NOTICE
This is a positive terminal only.
Do not attach negative lead!
NOTICE
Check zinc anode every 100 hours or 3 months.
NOTICE
Do not use as a step.
Standing on genset could impair operation of unit.
NOTE
Split lock washers may be supplied with some kits. If
split lock washers are supplied with kit, their use is
optional.