Engine (continued), Electrical system – Kohler 3.5CFZ User Manual

Page 55

Advertising
background image

TP-5695 12/93

Troubleshooting 4-3

Engine (Continued)

Problem

Possible Cause

Corrective Action

Overheats

Improper cooling

Check intake and outlet openings. Check
coolant level and pressure cap. Check raw
water strainer.

Thermostat defective

Replace

Sea strainer clogged

Clean sea strainer

Carburetor adjustment too lean

Adjust carburetor mixture

Engine ignition timing incorrect

Adjust timing

Unit is noisy

Exhaust system leak

Check exhaust system

Unit is noisy

Exhaust system not securely installed

Check for loose parts

Broken or damaged vibromounts

Check vibromounts

No installation clearance (unit hits craft
structure or compartment)

Check clearances

No compartment sound insulation

Install approved insulation

Excessive vibration engine/ generator
(internal imbalance)

See authorized Kohler service
dealer/distributor

Loose or vibrating sheet metal

Check shrouds

Electrical System

Problem

Possible Cause

Corrective Action

Battery will not
charge

Loose or corroded connections

Clean and tighten connections

Battery will not
charge

Sulfated or worn-out battery

Check electrolyte level and specific gravity
(batteries with filler caps only)

Defective battery charging system

Check charging system

Battery charging fuse blown

Replace fuse. If fuse blows again see
authorized Kohler service dealer/distributor

Starter does not
work properly

Loose or corroded connections

Clean and tighten loose connections

Starter does not
work properly

Low battery output

Check electrolyte level and specific gravity
(batteries with filler caps only). Check
battery voltage.

Defective starter solenoid

Replace starter solenoid

Defective start/stop switch

Replace switch

Defective wiring

Check wiring

Starter cranks
slowly

Low battery output

Check electrolyte level and specific gravity
(batteries with filler caps only)

slowly

Too heavy viscosity lube oil

Use proper viscosity oil

Loose or corroded wiring

Clean and tighten loose connections

High starter current draw

Rebuild or replace starter

Battery cable undersize

See Installation Section--Electrical
Systems

Advertising
This manual is related to the following products: