Krell Industries S-1000 - Manual (Page 25)

Krell S–1000 21
The S–1000 has balanced outputs with XLR connectors and single-
ended outputs with RCA connectors. Both outputs are active at all
times, allowing simultaneous connection to separate amplifiers.
Connect only one of these output formats to a single amplifier.
6. Connect the outputs of the S–1000 to the input(s) of your power
amplifier(s).
7. Connect the AC power cord to the IEC connector (59) on the
S–1000 and to the AC wall receptacle.
8. Move the back panel power switch (58) into the up (on) position.
The red power/stand-by LED (2) on the front panel illuminates.
The words
PLEASE WAIT, INITIALIZING
appear in the front panel display
(20). When the initializing message disappears, the S–1000 is
ready to switch to the operational mode.
9. Use either the front panel power button or the remote con-
trol pre key (1) to power on the S–1000. The blue power LED (2)
on the front panel illuminates. The S–1000 is now in the opera-
tional mode and ready to be configured.
Make sure that all source devices are off when you configure the
S–1000.
Connecting the S–1000 to Your System, continued
IMPORTANT
Last:
Connect Amplifiers
and Sources