Krell Industries S-1000 - Manual (Page 9)

Krell S–1000 5
Before you install the S–1000 Surround Preamp/processor into your
system, review the following guidelines to choose the location for
the component. This will facilitate a clean, trouble-free installation.
The S–1000 does not require any type of special rack or cabinet for
installation. For the dimensions of your S–1000 see Specifications,
on pages 66-67.
The S–1000 requires at least two inches (5 cm) of clearance on each
side and at least two inches (5 cm) of clearance above and below
the component to provide adequate ventilation. In addition, the
S–1000 requires at least three inches (7 cm) of clearance between
other connected components. For installations inside cabinetry,
extra ventilation may be necessary.
The S–1000 has superb regulation and does not require a dedicated
AC circuit. Avoid connections through extension cords or multiple
AC adapters. High quality 15 amp grounded AC strips are accept-
able.
High quality AC line conditioners or filters may be used if they are
grounded and meet or exceed the unit’s power supply rating of
100 VA.
Use the S–1000 only with the power cord supplied.
Placement
AC POWER
GUIDELINES