Krell Industries S-1000 - Manual (Page 61)

Saving and Recalling Customized Settings and
Restoring the Factory Default System Settings
Krell S-1000 57
To save the customized settings that you have entered, press and
hold the save button (25) for approximately four seconds. The front
panel displays
SAVING SETUP while the settings are being stored in the
nonvolatile memory of the S–1000 Surround Preamp/processor.
To retrieve your system’s saved settings, press and hold the recall
button (27) for approximately four seconds. The front panel displays
RECALL SETUP
while the settings are being retrieved from the non-
volatile memory of the S–1000. Any settings that have been saved
will be available through recalling system setup.
To replace all system settings with the factory default settings, follow
these steps:
1. Press the front panel power button or power pre key (1) to put
your system into the operational mode.
2. Simultaneously press the recall button (27) and the power button or
pre key (1). The front panel first displays:
RECALL SETUP
and then the front panel displays:
S–1000
VERSION 1.0
60 HZ
Customized settings for the S–1000 revert to the factory default set-
tings.
If you save your settings, they are still in memory after you restore the factory
default system settings. Follow Recalling Customized Settings above to
retrieve your customized settings.
SAVING CUSTOMIZED
SETTINGS
RESTORING
THE FACTORY DEFAULT
SYSTEM SETTINGS
RECALLING
CUSTOMIZED
SETTINGS
Note