LevelOne GSW-2692 - Manual (Page 119)

Port Configuration
3-83
3
• Target Unit – The unit whose port will “duplicate” or “mirror” the traffic on the
source port.
• Target Port – The port that will mirror the traffic on the source port.
Web – Click Port, Mirror Port Configuration. Specify the source port/unit, the traffic
type to be mirrored, and the monitor port/unit, then click Add.
Figure 3-49 Mirror Port Configuration
CLI – Use the interface command to select the monitor port, then use the port
monitor command to specify the source port and traffic type.
Configuring Rate Limits
This function allows the network manager to control the maximum rate for traffic
transmitted or received on a port. Rate limiting is configured on ports at the edge of
a network to limit traffic coming into or out of the network. Traffic that falls within the
rate limit is transmitted, while packets that exceed the acceptable amount of traffic
are dropped.
Rate limiting can be applied to individual ports or trunks. When an interface is
configured with this feature, the traffic rate will be monitored by the hardware to
verify conformity. Non-conforming traffic is dropped, conforming traffic is forwarded
without any changes.
Console(config)#interface ethernet 1/10 4-108
Console(config-if)#port monitor ethernet 1/13 tx 4-119
Console(config-if)#