Ip igmp snooping query-interval – LevelOne GSW-2692 User Manual

Page 364

Advertising
background image

Command Line Interface

4-186

4

Default Setting

2 times

Command Mode

Global Configuration

Command Usage

The query count defines how long the querier waits for a response from a
multicast client before taking action. If a querier has sent a number of queries
defined by this command, but a client has not responded, a countdown timer
is started using the time defined by ip igmp snooping query-max-
response-time
. If the countdown finishes, and the client still has not
responded, then that client is considered to have left the multicast group.

Example

The following shows how to configure the query count to 10:

Related Commands

ip igmp snooping query-max-response-time (4-187)

ip igmp snooping query-interval

This command configures the query interval. Use the no form to restore the default.

Syntax

ip igmp snooping query-interval seconds
no ip igmp snooping query-interval

seconds - The frequency at which the switch sends IGMP host-query
messages. (Range: 60-125)

Default Setting

125 seconds

Command Mode

Global Configuration

Example

The following shows how to configure the query interval to 100 seconds:

Console(config)#ip igmp snooping query-count 10
Console(config)#

Console(config)#ip igmp snooping query-interval 100
Console(config)#

Advertising