LevelOne GSW-2692 - Manual (Page 359)

Multicast Filtering Commands
4-181
4
Example
Related Commands
map ip dscp (Global Configuration) (4-177)
map ip dscp (Interface Configuration) (4-177)
Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to query for any
attached hosts that want to receive a specific multicast service. It identifies the ports
containing hosts requesting a service and sends data out to those ports only. It then
propagates the service request up to any neighboring multicast switch/router to
ensure that it will continue to receive the multicast service.
IGMP Snooping Commands
Console#show map ip dscp ethernet 1/1
DSCP mapping status: disabled
Port DSCP COS
--------- ---- ---
Eth 1/ 1 0 0
Eth 1/ 1 1 0
Eth 1/ 1 2 0
Eth 1/ 1 3 0
.
.
.
Eth 1/ 1 61 0
Eth 1/ 1 62 0
Eth 1/ 1 63 0
Console#
Table 4-63 Multicast Filtering Commands
Command Groups Function Page
IGMP Snooping Configures multicast groups via IGMP snooping or static assignment,
sets the IGMP version, displays current snooping and query settings,
and displays the multicast service and group members
4-181
IGMP Query Configures IGMP query parameters for multicast filtering at Layer 2 4-185
Static Multicast Routing Configures static multicast router ports 4-188
Table 4-64 IGMP Snooping Commands
Command Function Mode Page
ip igmp snooping Enables IGMP snooping GC 4-182
ip igmp snooping vlan static Adds an interface as a member of a multicast group GC 4-182
ip igmp snooping version Configures the IGMP version for snooping GC 4-183
show ip igmp snooping Shows the IGMP snooping and query configuration PE 4-183
show mac-address-table
multicast
Shows the IGMP snooping MAC multicast list PE 4-184